I knew you were looking at wax release agent
"Ex 815 general solvent wax release agent"
The product is mainly based on the formula of wax. The difference is that the wax particle size after our dispersion is as low as about 1 μ m, so the demoulding is very easy. On some simple molds, the number of consecutive demoulding can even reach more than 9 times. No matter MDI or TM system can be adapted, the mold temperature from room temperature to 90 ℃ is no problem.
Not only that, our product advantages lie in:
1】 No matter how the weather temperature changes, the wax in our release agent will not crystallize and turn coarse, so there is no possibility to block the spray gun, reduce the release performance with the temperature, bring visible white spots to the product surface, and avoid the possibility of rapid whitening of the mold and excessive scaling;
2】 The products we use directly, even when the content is only 1%, can still be kept for more than a week without stratification, which makes the products can still be used stably in the absence of mixing equipment;
3】 Our products will provide you with open hole surface. Of course, if you have special requirements, such as the need for closed hole surface, we are happy to help you.
4】 We use the zero organic tin formula, we are committed to developing the formula without "banned" chemicals, so as to solve your worries.
5】 We provide concentrated solution, and can also directly help customers to open the dilute solution to the appropriate proportion for direct use.
Ex 520 low temperature solvent wax release agent
Generally speaking, ex815 can be used for slow rebound foaming demoulding, but the production of slow rebound products is significantly different from that of high rebound products.
Generally, the mold temperature of slow rebound production is low, so slow rebound requires faster drying speed. Especially now, due to the limited production conditions of many small and medium-sized customers, spraying is easy to cause air pollution. Customers are more inclined to brush and paint for multiple demoulding operations, which also requires faster drying speed of mold remover.
At the same time, the surface of slow rebound products is often a little sticky, which also requires less demoulding force. Based on the characteristics of slow rebound, Youzhi has customized more specialized and efficient products. Compared with high rebound wax, it is a completely different type of wax. After dispersion, its particle size is smaller, and wax dispersion is translucent, which is a typical feature of small particle size.
Therefore, the continuous demoulding performance of the demoulding agent is better, and the number of direct brushing demoulding is more;
Less demoulding force;
Better opening;
Improve the sticky state of the product surface;
It is slower than crud;
We can completely dry the original solution of mold release agent in about 10 seconds without compressed air after brushing, which is convenient for use.
Our ex 520 can adapt to the temperature below 50 degrees. At this temperature, it can also perform well in the fields of hard foam, high rebound and so on.
contact us
Shanghai Youzhi Chemical Co., Ltd
Tel: 18516594711
Contact: Tang Tao
Website: http://www.yz787.cn
Address: No.709, Lingshi Road, Shanghai
In the past, we are looking forward to the recruitment of many sales managers! Star product | water based under mold release agent, who knows!
It must be used for skinning products -- water-based paint with excellent treatment
Long press QR code to follow Shanghai Youzhi, scan code to follow, and add friends
Shanghai Youzhi Chemical Co., Ltd
One finger, one finger, one finger!