Typical use of silicone gel:
1. Precision electronic components
2. Module power supply and circuit board potting protection with high transparency and restoration requirements

Use of silicone gel:
1. Before mixing, first mix the components A and B in their respective containers.
2. When mixing, observe the weight ratio of component A: component B = 1: 1.
3. It can be defoamed according to needs during use. The mixed liquid A and B can be stirred and put into a vacuum container, and then degassed at 0.08 MPa for 5 minutes, then it can be poured and used.
4. Silicone gel, before and after curing, should maintain the temperature given in the technical parameter table and maintain the corresponding curing time. If the application thickness is thicker, the curing time may be exceeded. It can be cured at room temperature or by heating. The curing speed of the glue is affected by the curing temperature. It takes a long time to cure in winter. It is recommended to use a heating method to cure at 80 to 100 ° C for 20 minutes. It usually takes about 8 hours to cure at room temperature.